Here's my log and screenshots. During this session it seemed to stop responding after several move commands. I tried to disconnect and reconnect to it during the log session.

Thanks for the help.

How is your Celeston GPS connected? serial port as well? If yes, I don't see it detected?

I didn’t have any other equipment connected. I was just trying the focuser after installing it.

Well, create a new profile then with only Telescope Simulator + CCD Simulator + MoonLite, and try that. Maybe because Celestron GPS was trying to use the same port, it was causing issues.

Ok, I’ll attempt one with only the Moonlite, and one with everything connected to be sure there are no issues.

Here's all the equipment connected. Moonlite will not connect now at all. I've provided a new log, plus new screens of both connection windows for the Celestron AVX mount and the Moonlite.

Thanks.

Also, here's a report of what is on the USB hub.

Thanks for the logs. I think you should start with something simple. Only connect MoonLite, and create a profile with Telescope & CCD Simulator plus MoonLite, and then try that. From the logs, two usb serial devices are there. Did you install the MacOS drivers for these USB to Serial adapters from FTDI?

Ok. This time I set it up with a CCD Simulator, Telescope Simulator, Guider simulator, and the Moonlite. I Rebooted, unplugged all devices, and rest the Moonlite motor by unplugging it from everything and plugging it back in. When I booted up went into EKOS and started INDI, the focuser would not start. I logged this session. Stopped INDI, and I tried to clear out the USB port connection information on the Moonlite connection tab. Then I quit EKOS, reset the focuser again, and then loaded up EKOS, started INDI, and it worked this time. I copied the USB settings from Device Profile, and took another log, moved the focuser a bit, then exited EKOS. All the information is attached.

I did previously install a driver for the USB-Serial cable I use to connect to my mount and control it. I believe I installed the Prolific driver from www.prolific.com.tw/US/ShowProduct.aspx?p_id=229&pcid=41 , but it has been a while. The USB Serial cable I'm using with the mount is from Sabrent .

Thanks, Let me know if I need to provide anything else.

You're getting resource busy error, so perhaps something in MacOS is using this port? I'm not sure what do suggest otherwise.

I don’t have any other devices plugged in, so how would I test it?

I’m wondering since I have a Serial to USB cable and driver installed for my NexStar hand controller if getting a USB version of the hand controller would eliminate this issue? I think the only way to test it would be to erase OSX and do a clean install with no USB serial driver installed to test the focuser before I make a purchase.