Run a test with all simulators devices (CCD guider, telescope, focus and filter) in a local configuration .
Kept "Renember Job Progress" not checked and used three filters.
Still the count is 0/0 and the scheduler tries to restart the job after completion.
Attached the full verbose log of this test (job completion is line 662. Line 1039 is where I manually stopped the job).
Thanks again for helping
EDIT: also run test with different 'Job Completion Conditions'.
'Repeats for 1 run' enters a loop of runs until I manually stop it.
'Repeat until <time>' repeats batches until it reaches the scheduled time and then triggers shutdown, as you said.
Same problem here, I noticed that it does not create a directory, like it did before,
but save image in Kstars/Light and remain in "capturing" ..have to stop manually.
Scheduler is very important.
Hi knro, I see your change, compiled and tested with simulators. Now photo is saved in just directory, only work remain in "capturing".
Add log and file used as test ( test photo of polaris without align, guide, ecc.. ).
Would it be possible to correct the scheduler?
It is a very important part of Ekos
I expose the problem, but my English is limited.
The problem is: when it finishes capturing the photo, it does not stop (and move on to another if present).
It remains in acquisition and the photo counter always remains at 0.
Ok just tested with nightly and it worked just fine.. I just found out that the nightly build in the PPA was failing, so I need to fix that as well first.