Dear development team.

Please tell me the setting value of the Alinment tab item set for the mount driver of DSC and Sky Watcher API.
Home position of automatic introduction machine → Unlike alignment of 2 or 3 stars, there are many setting items, constellation movement and constellation position do not become intended movement.

Recommended setting values ​​and explanation of each item are required.

Thank you.

Both are used with ALT AZ mount.

The Alignment stuff are currently being reworked by Jean-Luc, please wait a bit until the changes are merged back into INDI. I will let you know when you can test again.

I am always thankful for your help.
DSC 's check was delayed due to work change and move.
I attempted various settings, but it did not work.
I am looking forward to rework.

Thank you for your reply.
astro is the user name I am using. I am using port number 5000 and I do not set access right, so I will try it.

I am grateful that you have always helped me.

I tried both the DSC driver and the SkyWatcher API driver.

I have heard that both drivers are correcting the alignment tab items now, but there are definitely two items missing at present.

Please reflect it at the time of correction.

1. Setting the home position
There is no initial value setting as the origin of the direction of the telescope.
If you do not set this item you will not be able to determine the starting point of the encoder, so it will not be possible to introduce it accurately.

2. Mount selection
It is necessary to select either ALTAZ or Equatorial Mount and a calculation formula for that mount.

At present it shows the behavior as calculated by equatorial mount.

Please consider it when correcting the driver.

The DSC driver is still not updated. I am waiting for Jean-Luc changes first to the IAS then I'll look into DSC changes.. so stay tuned.

I am looking forward to it.