But SVN gets into PPA, yes? You mentioned 12-24 hours

3) Will retest;
4) If I remember it right the temperature is measured successfully after probe reinsertion, but still LED red. I will recheck tomorrow;
6) From logic point of view, as for focuser they represent Absolute Position, I can understand that, but the range is frustrating (up to 60000, which doesn't make sense in our case)

Thanks again for your efforts, I hope tomorrow I won't be reporting any other issues

3) Some very strange things are happening with current version of the driver - sometimes focuser is freezing Before any conclusions - how is working the Abort Motion in case of Relative / Absolute Position change? With Focus Times it's clear for me - you send :F3STOP0#
4) Working as expected, all good!
10) Please correct this message: updatePostion read error: Timeout error. to updatePosition read error: Timeout error.

Freezing in what sense? I'm not sending any stop commands, I just send the new move command. Am I required to stop first then issue a new move command?

In some cases I get updatePostion read error: Timeout error, but focuser is still accessible from Arduino (Serial monitor), in other cases focuser stop responding completely Right now I have checked the focuser - for stopping ANY motion just send :F3STOP0#

It is now more tolerance to errors, please check again. I also invited you to gmail chat, we can finish things there faster.

Sure, we can work in gmail chat, but tomorrow, I am already home

As far as I can see you haven't implemented the 3) from #2320, yes?

Is this necessary? Do you see the stop command being sent when changing absolute or relative positions in the original driver software?

No, but why not if it is working perfectly and Abort button is already there?

I added it no problem though I'm not sure if that will resolve any issues you have.

I understand that, but I like to pay attention to every detail About the issues - I have a feeling what it can be, tomorrow will test it out

As I can see you didn't implement :F3STOP0# command sending for abort button, yes?