adam grzesik replied to the topic 'CCD Camera Qsi' in the forum. 7 years ago

Tested working perfectly thank you

Read More...

adam grzesik created a new topic ' Robofocus Devices' in the forum. 7 years ago

Robofocus not doing steps when pressing focus out or in, in Ubunto mate 16.04. Works perfectly in Ubuntu 16.04 and 17.04.

Read More...

adam grzesik replied to the topic 'CCD Camera Qsi' in the forum. 7 years ago

Thank you

Read More...

adam grzesik created a new topic ' CCD Camera Qsi' in the forum. 7 years ago

Qsi filter wheel, after doing a upgrade unable to add a name to individual filter. Qsi CCD device crashes. Iam running 16.04 also tested on 17.04 does the same. The version of the Qsi ccd device is 3220 i think. Has any body had the same???? Is there a fix.

Read More...

adam grzesik created a new topic ' QSI CCD filter wheel naming' in the forum. 7 years ago

Qsi filter wheel naming throughing an error after i did an upgrade, worked perfectly before???? Qsi service crashed

Read More...

Thank you Adam

Read More...

Success, connected to the Arduino. You mentioned "Connect your relay box to arduino as instructed in indiduino site" I cannot find any maybe I am just getting old. Could you nudge me in the right direction I would appreciate this as I am literally days old in using the Arduino. Can I use any of the relay board for the Arduino?

Many Thanks Adam

Read More...

Arduino has a usb port and I didn't upload indiduino. I am not shore how to do this or what version type and where to download it from, I am very new to Arduino.

Thanks again

Read More...

hi
I've checked the port it is correct . ttyAMC0. What do you set up on the Arduino? this bit I don't understand.

Thanks for replaying

Read More...

Hi
Thank you for your replay.

Read More...

Hi
New be to the Forum .
Firstly I would like to thank you for a most amazing interface. I have managed to put the necessary parts together and I am controlling my telescope ccd through Raspberry remote and client. So I tried Arduino basic switcher and everything went ok and connected to the driver. Client showed gui interface with all the sockets, I pressed the connect button and all I got was a yellow light?? I disconnected Arduino and reconnected with the client and I got a red light. So I am connected but nothing is happening. Hopefully you could enlighten me what to do next and is it my mistake.

Hope to hear from you soon joe90

Read More...