I have similar problem.
telescope driver : astro-electric FS-2
guider driver : qhy ccd

in guide tap, I cannot select via "FS-2". Just "qhy ccd " can be chosen.
Could you fix it?

same problem occurred when I used 'LX200 10 micron driver'
FS-2 driver worked well.

Read More...

i'm testing at home.
astro-electric fs-2 driver activated the speed selection.

Read More...

Can I get the older version, instead?
Other drivers cannot handle my mount.

Read More...

I'm using LX200 basic driver.

Read More...

At any rate, I completely abandoned GOTO and instead went with the simple Go West, and Go East controls.
by KNRO
indilib.org/forum/ekos/4312-help-require...riment.html?start=12

Maybe this can be a problem.

Read More...

other mount function is good(tracking, plate&solve-sync, manual rotaion)
so I'm rotating mount manually, typing RA and DEC.

Read More...

recently I got update my raspberry pi.
Then I see the "speed" selection on the polar alignment assistant. but I cannot select anything-nothing appears! (west/east selection is ok)
and EKOS cannot rorate my mount(CRUX170hd, using LX200 protocol, made by HOBYM observatory)

what's wrong? before update, everything was good.

Read More...

hello.
I'm using some FUJI mirrorless cameras, but they cannot be connected by Gphoto.
Can I use ONLY serial shutter cable , without Gphoto connection?
If possible, I can do dithering with Kstars/EKOS guiding function. It will be helpful for reducing noise.

Read More...

The connection was refused by the peer....

mount : ioptron zeq25 ( connected by indi)
Camera : sony a7s ( connected by indi)
Guide camera : QHY5L2-M ( connected by Lin_guider, not Indi)

Thanks. Then I should use external guider....

How can I connect external Lin_guider? Connection was refused..