ScopeDome is included with libindi > v1.7.6. To install it under Ubuntu:
sudo apt-add-repository ppa:mutlaqja/ppa
sudo apt-get update && sudo apt-get install indi-full
ScopeDome controller can be used with a classic observatory dome and also roll-off roof, but the driver has only been tested with a dome so far.
ScopeDome is a fully automatic observatory dome control system. It also has a variety of sensors and relays to control power to other devices. Link your dome to a computer for complete automation including telescope slaving and shutter control. It supports the following features:
- Slave dome rotation to your telescope
- Rotation-only and full shutter-and-rotation systems available.
- Direct confirmation of shutter open/closed state.
- Safety interlocks automatically close dome upon loss of data from PC.
- Park-before-close option to avoid mechanical interferences.
- Manual override controls for shutter and rotation control
- Field-upgradable firmware
The driver supports controller version 2.1 and has been tested with firmware versions 3.52 and 3.70. Currently the driver does not have functions to calibrate steps per revolution of the dome, which has to be done with the Windows driver setup software. Also it is strongly recommended to generate an inertia table and copy it to ~/.indi/ScopeDome_DomeInertia_Table.txt
Once you are connected to the dome, you can move it in absolute or relative position. You can slave the dome to the mount by setting the required slaving parameters:
- Radius is for the radius of the dome in meters.
- Shutter width is the clearance of the shutter of the dome in meters
- N displacement is for North displacement. If telescope is not in its ideal central position this parameter allows to configure how much it is displaced from the center. Displacement to north are positive, and to south are negative.
- E displacement is for East displacement. Similar as the above, displacement to east are positive, and to west are negative.
- Up displacement is for displacement in the vertical axis. Up is positive, down is negative.
- OTA offset is for the distance of the optical axis to the crossing point of RA and DEC. In fork mount this is generally 0, but for German like mounts is the distance from mount axis cross to the center line of the telescope. West is positive, east is negative.
After settings the parameters above, go to Options tab and click Save in Configurations so that the parameters are used in future sessions. You can also set the Autosync threshold which is the minimum distance autosync will move the dome. Any motion below this threshold will not be triggered. This is to prevent continuous dome moving during telescope tracking.
There are no known bugs for this driver. If you found a bug, please report it at INDI's bug tracking system at SourceForge. (You can log in with a variety of existing accounts, including Google, Yahoo and OpenID.)