Kstars 3.5.9 on Raspberry Pi4 - I have a ZWO ASI1600MM as a primary camera and an ASI120MM as a guide camera both connected via the indi_asi_ccd driver. Is there a way to force Ekos to know which camera is the guide and which is the primary? On Ekos startup I have to go through the main dialogue of camera, guide, etc and manually verify/change the entries for the correct ones as some are incorrect which is a pain. I am sure I never used to have to do this and when set it always worked from then on (I think!). On my ASI533 camera, under options, there is a setting to set either primary or guide but there is no such option for the ASI1600MM or the ASI120MM. Do I have to use the 'ZWO camera 1/2' driver or something? Help please!

Please update to KStars v3.6.1 with optical trains.

Thanks Jaseem - when upgrading I was aiming for 3.6.1 but on doing:
sudo apt-add-repository ppa:mutlaqja/ppa
sudo apt-get update
sudo apt-get install indi-full kstars-bleeding

It installed 3.5.9 - any way to force 3.6.1 download?