So, in Guide Module - Control Parameters - when those go in effect?
Immediately? After dither? After re-calibration?
Also - left is for RA, right is for DEC, right?
Thanks!
-- Max S
ZWO AM5. RST-135. AZ-GTI. HEQ5. iOptron SkyTracker.
TPO RC6. FRA400. Rokinon 135 and other lenses.
ZWO ASI2600MC. D5500 modified with UVIR clip-in filter.
ZWO ASI120MM Mini x 2. ZWO 30F4 guider. Orion 50mm guider.
ZWO EAF x 2.
2) Yes. Left RA, Right DEC.....but the RA side is not used if you are using the GPG guider (and I'd recommend that you do use GPG). It should be (but isn't) greyed out when GPG is in use.
BTW, I agree completely that this interface should be updated and hope to move these controls to the options menu triggered by the options button in the lower-right-corner of the guide tab, and perhaps rework that UI.