Hi guys in these first attempt to use qhy294m with astroberry, sometimes ekos crashed and automatically close all windows!! This is a huge problem that bring me away a lot of time. Also sometimes happen that the camera connection fall down and i must restart driver or disconnect and riconnect the camera.
Please can anyone help me?

Thanks a lot and sorry for my horrible english i'm italian  

Hello,

Please advise more information about your setup, software versions, and then, try to run KStars through the debugger and check all options before you start to get full debug information.

  Of course! My equipment is: QHY294mm pro( QHYCFW3), Asi120mm mini,astroberry focuser, indi eqmod.Here in attached i put the last logs file of kstar. Looking at the file i can't see anything that reporting a crash, but only some captuer aborted, but i'm sure that during this interval ekos and kstar crashed.  

I would suggest enabling ALL debugging options on both Kstars and INDI tabs, as well as the INDI capture driver. you do that by disable auto-connect on your profile, then start the profile, and before you press connect, go to the camera tab, and look for the debug options, select all, and make sure you write to a file, then connect your profile.

You will have 2 files to use, the kstars log and INDI driver log

    Hi, i've enabled all debug i think, i've created a profile with only QHY driver and i've tested it doing a bias. After 2/3 frame the connection with the camera fall down, even though this time ekos isn't crashed.

Leave in attached the logs file.

In any case thanks a lot for the support 
 

Hi Luca,
Could you try this command in a terminal and see what it gives four you ?If it's equal to 16, It's probably due to usb memory. Try with this command below and after that see if you still have the problem:
Regards

Hi, the return value is 256

Hi Luca,

Did you have a look to this thread ?  : 294 mono - indi

Hope it helps...

Regards

Thanks for the advice oui, but yesterday i've tried to use CCDciel instead of kstar, but the problem still be present. If i try to do a sequence of bias after some frames the software lost the connection with the camera. This suggest me that the issue is in the indi drive of the camera maybe.

What do you think?

Thanks