Where does EKOS store focus settings? I normally set binning to 2x2 and filter to lum. However on a fresh start of kstars this is always set back to 1x1 and RED (first filter in wheel)
I have it drop my setting in all areas ALL THE TIME. Really frustrating. For my dome I captured the settings page so I could more easily put them back without calculating them again.
But I didn't capture my weather watcher settings = ( The most difficult to configure and I'm forced to do it again.
All my settings - LOST ? WHY IS THIS?
AP Mach1 / CP4 APCC & PEMpro.
EXP SCI - ED152cf APO - Celestron 11" RASA - Stellarvue 80mm
Baader F2 HS NB filters, Lodestar X2 guide camera / OAG - ZWO 290mm mini
ZWO ASI1600MM Pro / ASI174M (solar) / ASI094MC
NEXDome, CLoudwatcher, AVX mount/ASIair and Stellarmate
It used to remember settings for me. Until I updated recently. I hadn't updated in about 9 months or so and I also did an ubuntu dist-upgrade from 16.04 to 18.04.
Its probably something somewhere that just needs to be deleted/cleaned
Just checked and both domes and weather parameters are loaded fine if previously saved (Options --> Configuration --> Save). I tried changing min, max, warning % .. what value not getting saved exactly?
Derek,
The binning was broken, but the reset of the settings (like filter wheel) were never saved before.. I'm adding that now...
Ok I already pushed the changes, now it remembers last selected filter wheel, filter, binning..etc.
"Save Configuration" is for INDI driver settings, not Ekos. If you "Save Configuration" for INDI driver, then the driver settings are remembered regardless of the client used.