×

INDI Library v2.0.6 is Released (02 Feb 2024)

Bi-monthly release with minor bug fixes and improvements

ASI183MM PRO Offset

  • Posts: 16
  • Thank you received: 0

Replied by Florian Vamosi on topic ASI183MM PRO Offset

Thanks Jasem!

I have built from source from Git. I don't seem to get the entry in the FITS header, but I don't know a way to verify If I actually have the right version. KStars itself reports version 3.4.0. in the logs(quoted below). Do you think I have the right version?
4 years 2 months ago #48574

Please Log in or Create an account to join the conversation.

  • Posts: 554
  • Thank you received: 138

Replied by Chris Rowland on topic ASI183MM PRO Offset

It's in indi 3rdParty, not kstars
The following user(s) said Thank You: Florian Vamosi
4 years 2 months ago #48575

Please Log in or Create an account to join the conversation.

  • Posts: 16
  • Thank you received: 0

Replied by Florian Vamosi on topic ASI183MM PRO Offset

Yup, I now see, Thanks! I am not on ASI Driver 1.6 yet. I can't imagine why, since I built everything from source again. Will try Again.
4 years 2 months ago #48577

Please Log in or Create an account to join the conversation.

  • Posts: 61
  • Thank you received: 2

Replied by Dirk on topic ASI183MM PRO Offset

Hi,
Yesterday, I managed to take a few subs between the clouds, and I can confirm, the OFFSET header is there.

Regards

Dirk
The following user(s) said Thank You: Florian Vamosi
4 years 2 months ago #48599

Please Log in or Create an account to join the conversation.

  • Posts: 16
  • Thank you received: 0

Replied by Florian Vamosi on topic ASI183MM PRO Offset

Hi Dirk,

That's awesome! I have not managed to recompile Indi3rdParty yet. It fails on dependencies of the Atik Driver. Havent'had time to investigate yet, but I'll try again today.

All the best,
Florian
4 years 2 months ago #48613

Please Log in or Create an account to join the conversation.

  • Posts: 16
  • Thank you received: 0

Replied by Florian Vamosi on topic ASI183MM PRO Offset

I have now successfully installed version 1.6 of the ASI driver. I can also confirm the offset entry is in the header. Thank you Jasem! This will save a lot of headache for a lot of us ASI users.

All the best,
Florian
4 years 2 months ago #48614

Please Log in or Create an account to join the conversation.

Time to create page: 0.769 seconds