Do you know its IP address and port? If yes, then just put those under Connections tab of the Losmandy driver and then connect right away. Make sure Ethernet is selected there first.
I was able to connect to Gemini 2 over internet. Thanks for your help.
I noticed one thing on the location settings though: I have set my location on Gemini HC as Lat = 29.45 N and Long = -95.21 (to indicate W). But the location information shown in EKOS/INDI are Lat = 29:45 and Long = 264.38
Based on math the long displayed in INDI is 360 - 95.21, but I want to confirm if the location is being set correctly. As far as I remember, this behavior is not seen in EQMOD that I tested before with my other mount.
Once again, thank you so much for great astroimaging package.