Version 2.0.11 (1.0.0.2176)

Options>Debug ... and set levels without Scope verbose
Configuration>Load
Main Control>Connection>Connect The Load correctly picked up to connection port.
On Set>toggled to all values and left on Slew
Eq. Coordinates> 	Coordinates match those on Handbox
	Successfully drove to a couple of RA, and Dec.  Fields updated during Slew.
Abort Motion> Abort 	Stopped current motion.
Park>Park				Worked.
Park>UnPark				Beep.
Home>Go to Home			On first press error Home search not supported
						On second press mount drove to home (NZ).
Home> Set current as Home	After manually moving scope did this command
Home> Go to Home			Went to new home.
Home> Set current as Home	After moving scope back to NZ
!!  Tracking Mode>			No selection gave Lunar.  Lunar always results in Sidereal.
Options>Driver Info Name:iEQ, Exec:indi_ieq_telescope,Version 1.0,Interface 5
Options>Scope Properties	Blank, Successfully set scope parameters.
Motion Control		N/S, E/W at all rates seems to work
Motion Control Guide N/S	I canot see a change in coordinates on the Hand box for
5000msec
Site Management > UTC	Fields are unpopulated.
					Set UTC Time and UTC Offset using INDI data/time format and
					-6:00:00 for UTC offset..  Changes were shown on Handbox.
Site Management > Scope Location	Fields are unpopulated
					Interesting:	Entered 40:00:00,-105:00:00 Error range 0-360
					Entered 40:00:00,255:00:00  Status box shows Site location
					updated to Lat 40:00:00 - Long -105:00:00
					Handbox correctly updates.  It shows W105
Site Management > Park Position
					Successfully changed park position
Main Control >		Park
					Drove to park position just set
!!Main Control> Home	Did not drive but said setting current as home. Drat.
Mount Info>Firmware Info	Matches the Handbox
Mount Info>GPS		Correctly shows Data OK
Mount Info>Time Source	Says Controller.  I would have expected GPS
					Maybe setting the UTC time changed the source
Mount Info>Hemisphere North