Frank Großmann replied to the topic 'FocusLynx Motor selection' in the forum. 6 years ago

I‘m connected over usb. I‘ve just seen i have to set the maximum ticks. Maybe it‘s because of that?

Read More...

Frank Großmann replied to the topic 'FocusLynx Motor selection' in the forum. 6 years ago

No I have a different effect. I have to sync every time before I can move focus at all.

Read More...

Frank Großmann replied to the topic 'FocusLynx Motor selection' in the forum. 6 years ago

Thanks for your hint! I figured out now that I have to use “quick sync ft hi-speed to work properly.

Best regards
Frank

Read More...

Frank Großmann created a new topic ' FocusLynx Motor selection' in the forum. 6 years ago

Hello,

which Motor shall I select when I have an HSM20? Is this Motor already supported?

Product Page

Best Regards
Frank

Read More...

Thanks for your help!

I take the roll_off driver as template and use the gson source and header directly from weather folder.

Clear Skies!
Frank

Read More...

Hello,

my name is Frank and I'm new here. I like to write a indi driver for my observatory roof using a Raspberry PI with the Razberry Z-Wave Module which has an Restful API.
I use two Z-Wave door sensors as limit switch and a Z-Wave relay to pulse my modified garage door opener. I have already an configured test setup on my table and i can simulate all steps manually by the browser.

I plan to make the api calls with curl but i need to parse the response from json.
My current issue is to find a common license compatible c/c++ library.

Can you give me some recommendations?

Read More...

Hello,

my name is Frank and I'm new here. I like to write a indi driver for my observatory roof using a Raspberry PI with the Razberry Z-Wave Module which has an Restful API.
I use two Z-Wave door sensors as limit switch and a Z-Wave relay to pulse my modified garage door opener. I have already an configured test setup on my table and i can simulate all steps manually by the browser.

I plan to make the api calls with curl but i need to parse the response from json.
My current issue is to find a common license compatible c/c++ library.

Can you give me some recommendations?

Read More...