Hello,

I have an install of INDI 1.8.0 built from source on a Raspberry Pi. I have OnStep installed onto an STM32 Blue Pill based PCB. I connect the RPi to the STM32 via WiFi link, which works fine.

Loading Kstars and opening Ekos I can connect, over wifi, to indiserver using the Ethernet method.



However, after the initial connect there is no further data exchange, no control works and I can't slew the scope at all. I have posted to the OnStep group ( onstep.groups.io/g/main/topic/32712176#12458 ) and others have similar results. I can get the scope to run fine by connecting the STM32 pcb to the RPi via USB.

Is there something I am missing in the configuration, or does it simply not work yet?

Read More...