Hi Everyone,

I've been running into an issue and I thought I'd report it here.

Background:
I'm running 2 Pegasus Astro devices that need to be mapped to a port otherwise both don't work.
I've recently purchased a ZWO ASI533 and want to add it to my setup. I run a ZWO ASI120mm mini as a guidecam.
I'm in the process of upgrading my PI3 B to a PI4 (4GB).
I mostly use the EKOS client on Windows 10.

Issue:
Running 1.5.3. on my PI4 only one ZWO camera shows up in the INDI panel.
When both are connected only my ASI533 (Main Camera) shows up.
When I disconnect the ASI533 and I reboot, the ASI120MM Mini shows up instead.
I am, however, able to map my Pegasus Astro PPBA and FocusCube V2 to their USB ports and they work fine.

To further complicate things, on my PI3 both camera's always show up.
I did have issues mapping the PA devices but it turned out I was running an older nightly build on my PI3. (My bad)
For now, my only solution is to run 1.5.3. with all updates on my PI3 and accept the USB2 speeds.

If there ie a better place to report this issue please let me know. Haven't done that before.

Read More...