what is the last Version of Ekos with a working Sbig AO8 and where can i get it?
thx, Joerg
Read More...
it is a LX200 10" from the mid 90's, firmware is 3.20 or 3.21 (not sure, had to take a look, next time i use it)
maybe newer firmware is more tolerant.
on the other hand i have never seen an original Meade document where ":" is used as a seperator for this command.
where does this ":" come from?
regards
Read More...
it is a LX200 10" from the mid 90's, firmware is 3.20 or 3.21 (not sure, had to take a look, next time i use it)
maybe newer firmware is more tolerant.
on the other hand i have never seen an original Meade document where ":" is used as a seperator for this command.
where does this ":" come from?
regards
Read More...
=16.6pxi had the same Problem with a LX200 compatible mount. it did not move.
the driver sends the command ":SdsDD:MM#"
according to the meade original lx200 docs it should be :SdsDD*MM#
see www.meade.com/support/LX200CommandSet.pdf
problem is in
lx200driver.cpp
int setObjectDEC(int fd, double dec)
regards
Read More...