I've recently gotten a PPBA and tested this out.
When I change the Adj voltage to off I can't set it back on again, it goes back off directly.
Any idea what's going on there?
I intend to use this output for fan speed control. Need fan speed to be high in the start, before imaging.
Then as I do the alignments I switch it to low setting and it's off during the rest of the night.
The dew heater outputs would potentially be good for this, but I both use them (main & guide scope).

I'm using a Mele quieter with Kubuntu, Kstars & indy from PPA mutlaq.

Thanks a lot for your suggestions!
Bart

Read More...