Hi,
I am new on the forum and just a little experience with ekos/indi, running under ubuntu 22.04. I've just purchase the risingcam ATR3CMOS09000KPA.
Everything seems to work fine, but I'm not sure about which parameters to set for this cam.
Do you know if a manual explaining all the available parameters is available ?
If I look to: www.indilib.org/individuals/devices/came...toupcam-cameras.html , the doc is old and doesn't correspond to what I see on my screen (I'm using the last driver release).
If not can you tell/explain me parameters inside the control panel ?
Hi everyone
Yes,. A little guiadance and explanation as to what settings to use would be great. These are the settings I have.
Default, apart from the offset:
Basically the same here - *except* I always use Low Noise Mode ON. I have never seen a reason to not use it.
I also run my heater at 4, because I had problems with frost forming on the sensor window. Mine is an early Risingcam, and I believe they may have improved the heater in newer versions.
I do fine at offset 300, but there's no harm in a bit higher, either.
Teleskop Express have posted a video on YouTube that might help explain some of the settings. Although they don't use INDI they still mention the equivalent settings from the native driver