Hello

I followed the advice and made the following particularly important DSLR settings.

>Option.
/Force Bulb ; ON
>Setting.
/Capture ; Off

In order to let EOS_M6 operate the EOS_M6 correctly remotely, I realized that it is important to set [Capture] in [Setting] to [off], especially if the latest saved photos are displayed on the DSLR's rear LCD display.
Immediately after connecting the USB to EOS_M6, starting up EKOS and connecting it to the INDI, the photo displayed on the rear LCD is off. After that, by setting [Capture] in [Setting] to [off], the display on the rear LCD will again show the photos stored in the SD card.
In this state, the camera can be operated by EKOS for the first time, the shutter is released, the photo transfer is done, and Live View can be displayed. I was very happy when I noticed this operation.

However, after it was working fine, the EOS_M6 would often malfunction again when I changed the settings on the INDI or EKOS side. We have not yet been able to identify the operation that can cause the problem. If this happens, turn off the EOS_M6, close the EKOS/INDI, turn on the EOS_M6 again, start the EKOS/INDI and perform the first setting (Capture=Off, display the pictures stored on the rear LCD) to reset the EOS_M6 and make it operational.

Again, we found out that the important point is to use the Capture button in the Setting tab.
I think this operation is a command to prepare for the INDI operation from EOS_M6 side, so I will be very happy if this problem is solved by INDILib.

thank you

Read More...