I was wondering if there is an issue with the Meade DSI driver? I have had no success when trying to connect this camera.
020-03-05T11:37:45 Unable to establish:
+ Meade Deep Sky Imager
Please ensure the device is connected and powered on.
2020-03-05T11:37:40 INDI services started on port 7624.
2020-03-05T11:37:40 Starting INDI services...
The Camera driver has been selected from the drop down menu in the profile editor, but will not connect.
Follow the instructions in step 3. Once you've started gdb, then open up ekos. Click "Add new profile" under "1.Select profile". Change the Mode from "Local" to "Remote" and then select the "Meade Deep Sky Imager" for the CCD. Leave everything else at the default and hit save. Click the "Start" button under "2. Start and Stop Ekos". I'm hoping you'll see the driver crash and drop into the GDB shell. If that happens, type "bt" and hit enter and then post the results here.
I think I have the correct log for you.
I am using Ubuntu studio on both 32 and 64 bit machine . Both will not connect to the DSI in Ekos using the meade driver int he dropdown list.I have attache the log file.
With the DSI plugged in I then went to the start button in ekos to open my profile. I only have the Meade DSI in my profile.
There appears to be something wrong with your installation. The DSI driver is missing a symbol, which is likely caused by a missing library. Did you install indi via apt or dpkg? That shouldn't allow this to happen.
Can you post the output of the following command:
ldd $(which indi_dsi_ccd)