Hello,
I use SM 1.8.1 on a RPI 64b 8G.
I've connected a ASI 224MC + ASI1600MC + EQ6.
I've updated the firmware of my EAF, and it works with ASICAP Windows.
When I want to use my EAF ZWO (old generation 12v) with Stellarmate, I don't see it.

I've created a simple configuration with only one camera and the EAF. When I start Ekos, I see my two cameras and not my EAF. I think I have a conflict between my ASI 224 + ASI 1600 + ASI EAF.

How can I investigate to find a solution ?

Iv'e used this EAF for a long time without a problem...

Thank you,
Frank

In fact, if I unplug all my devices and plug only my EAF, I see it.
If I plug my ASI 224 + 1600 after my EAF, no problem.
If I stop my Stellarmate session and restart, I need to unplug and plug my EAF to see it.
It’s an old problem but it’s a solution. Yesterday, despite the action of unplugging and plugging, I didn’t see my EAF…
I changed my cable and my power supply but it’s always the same problem.

Is your power supply able to feed the USB devices?

There used to be two drivers available for those units: ASI EAF and ZWO EAF. The ASI version has been removed - the one that I was using till now.

I had issues too, especially with my filter offsets that I have to rebuild.

Take a look on this, just my two cents.

Hello Jerry, yes, I've a separate power supply only for this EAF

Ok, thank you, I'll check that.