Hi,
There are still issues with this in 3.6.2.
There is still no pause for Darks or `dark flats.

Ran the following sequence.
2 x Lights
2 x Dark
2 x Flat
2 x Dark Flat

At the start of the sequence get a warning to remove the dust cover with a 60 sec timer
Takes the 2 light frames
Takes the 2 Dark frames
Get a pop up saying to illuminate the lens with a 60 second timer
Takes the 2 flats
Takes the 2 dark flats.

The flat calibration settings were both set to manual.
Setting the calibration to dust cover with external light passes straight through the sequence with no pop up for illumination.

As a side note, the 60 sec timer would be better replaced if possible with an infinite timer as if the telescope is remote it may take longer than 60 seconds to get to and prepare the covers.

I am very new to this and my next challenge to to work out how to use the GIT hub so I may test any updates as you requested previously.

Thanks very much
Greg

Read More...