Hello,
I have a stellarmate OS.
On my terminal, "uname -m" give me a "armv7l", so 32 bits?
Does Stellarmate OS exist with 64 bits?
Read More...
Really the same issue, after update of my Stellarmate.
Autofocus after guiding procedure. In linear mode, the focus move to +200 steps, and the autofocus procedure seems to be blocked.
I tried without the focus (on schedule), but it's the align module that seems to be blocked.
Kstar crashes if stop the procedure (focus or align).
Read More...
Same issue, new instalation on 20.04 ubuntu
indi-full can't install if kstars-beelding installed
indi-gphoto and indi pentax seem to be an issue.
Read More...
Hello, i change my setup
Before in this topic:
indilib.org/forum/gallery/1014-post-your....html?start=60#42277
Stellarmate on RPI4 (box Argon one), Power box GX12 connector 2pins (home made), Hub usb3 12V startech powered (and RPI4 powered with this), EAF ZWO, QHY183M (with FW CFW3), Evoguide 50ED SW with QHY5LII-M and GPS.
TSA102 on AZEQ6.
[Warning: Spoiler!]
M27
60x180s L Filters
10x180s RGB Filters
Submit
Read More...
Hello,
Same problem as yours.
Lastly, I observe problems on the regulation of the temperature of my QHY183M.
The behavior is random, the automatic regulation works, the next day not.
Ditto with manual control, it works for two or three inputs, after the command does not seem to reach the camera.
I would post the logs for the next test.
Laptop or PI, with two QHY cameras (183M and 5LII-M).
Read More...
Nice software, simplicity and efficiency.
Some try... with canon 450D, 20 secondes on 80ED (old files)
Read More...
I have the same "problem". I have the preset Tab for different focus.
I wish, if possible to have it on the scheduler :at start up and shutdown.
i think it s possible with scripts on scheduler but i dont' know how i do this... . (command line for focus in/out with pitch value)
Read More...