So I have started testing the CEM25p mount, but this post is not directly related to this specific mount.
I have set the above to 30 / 90 this is purely for testing purposes.
Issue: mount is allowed to carry on slewing on additional presses of the slew button.
As shown in the log file:
As you can see from the above, the mount stops slewing once it reaches the altitude limit of 30, however I was able to issue a few more slew commands and the mount did move.
Just a little bit, then it stoped as it had reached the limit.
I personally believe that if the mount has reached that limit, you should not be able to send another slew command. The mount should not move.