As already discussed the ASIAIR Pro (which is a Raspberry Pi4) can be operated with the SM OS. Just flash the SM OS to a fresh microSD card and boot
the ASIAIR pro up. However, as mentioned by Laurent.Wolff, in this "normal" Stellarmate configuration the 12 volts power output ports do not operate.
I have an ASIAIR pro in use, the 12v ports are configured "on" or "off" in the ASIAIR app. If you turn on all 12v ports in the App, then the power ports are
immediately available upon booting the ASIAIR with the ASIAIR OS, no need to start the app on the tablet, so the configuration is stored within hardware
I had a closer look on the ASIAIR pro microSD card and looked into the file config.txt. The power outlets are configured there, when they have been turned on
previously by the ASIAIR app.
So, I took the Stellarmate OS microSD and edited it's config.txt.
Simply change the config.txt in the [pi4] section and add 2 additional lines in front of the [all] section like this:
# Enable DRM VC4 V3D driver on top of the dispmanx display stack
# I2C Bus
# 2New lines here
#Enable 12v gpio output
I have attached the config.txt file for those of you who are not familiar with file editing. Just copy the config.txt to the root directory of the SM microSD card.
When booting up the ASIAIR pro with the edited SM microSD card, the power outlets are available upon bootup.
I have successfully operated both the camera cooler and the electronic focuser using the 12V power ports with Stellarmate.
Hope this helps anybody who wants to operate the ASIAIR Pro with the much more powerful Stellarmate OS!!!!!!!
I installed Stellarmate 1.5.4 on an SD card and inserted it into my ASIair Pro box. I cannot connect an Android device (Samsung S8/S9/tablet) to it even though it shows up on a scan for devices. The app doesn't fully open. I tried to download the updated APK in the DropBox link but DropBox says it's been deleted. Where can I find the APK or is there another way to solve my problem?
No, don’t delete anything, those lines are needed, and I have all the same as you...
Stellarmate OS on Raspberry pi4b
Skywatcher EQ8 pro, on steel pier
Takahashi FSQ85, FS60cb & Meade 8” SCT (de-forked)
Starlight Xpress SXVR H18, SXVR M25c, Lodestar x2 Guide Camera
Pegasus Ultimate Hub V2 for all USB & Power
Pegasus focus motors on all scopes
Ii was the original ASIair and I didn't get Stellarmate working. My problem was my total lack of familiarity with the Indi world. I did get my Sony A7R recognized at some level but couldn't navigate through the architecture to figure out what i needed and how to make it work.
I have an ASIair Pro now and an ASIair Plus arriving next week. If I get bored I could try again with the Pro model.
For Your information I succeed on making stellarmate working on ASIAIR pro easily.
Just install OS in sdcard and make modifications in configuration like described above to make DC outputs working.